During the day – Time range when this address have to be visited. You can specify a more precise time or leave it as is. Default values can be changed in the Settings tab

ASAP – If this option is selected, the route will be formed so that this address would be visited as soon as possible.

Service time - It takes into account service time at this address. Default values can be changed in the Settings tab

Units - How much units will be carried to/from this stop

Note: if you specify the units for stops, the system will limit the number of stops in route based on the maximum capacity specified in the Settings tab.

Priority - Setting this parameter gives priority to this address. If it is not possible to visit all the selected stops in given constraints, then preference will be given to the addresses that have priority, and the others can be excluded from the route.

Note: This value is not absolute, and the address with the set priority can be excluded from the route if the visiting conditions conflict with another address with the ASAP option.

Start time – When you want to start your route

NOTE: Start time can not be least of minimal time windows of any stop.

Start from and Finish at: there you my specify from where you would like to start and where route should be completed

Optimize time or distance – Allows you to choose less time on road or less distance

NOTE: total travel time does not include cumulative service time on the stops

Idle time – Maximum allowable idle time if you arrived to stop ahead of schedule. All stops where idle time will be greater of given value will be excluded from route. Default values can be changed in the Settings tab

NOTE: if the time is not explicitly indicated, then it is not taken into account in the calculations.

Start time – When you usually start your tasks

During the day – Specifies default value of time range.

Service time - Specifies default value of service time at stop

Movement type – Depending on this value, the route will be built for driving or walking

Capacity – Indicates how many units you can carry. For example, the vehicle has 50 shelves for water bottle

Note: if you set “0” then this option never will be used in optimization

Number of routes – It is used if the capacity value is not equal to “0”. In the case when capacity is insufficient, the system can plan several routes with reloading at the STARTING POINT

Navigation – Default action for navigation applications